The attachment is based on the LE AUDIO transceiver firmware implemented on R496.1 QCC3084: Receiver side UI: Click: play pause, answer and hang up Double click: switch to launch mode Long press for 1s to release: Reject Long press 3S to release: pairing Long press 6S to release: switch machine Launcher UI: Double click: switch … Read more
Product description： 1. Click on the test, the result shows the frequency, power, and frequency offset value of the current Bluetooth device, the approximate time is 1.5S 2. Click calibrate to automatically calibrate the current frequency, write the value of the calibration number to the Bluetooth device, and display the frequency, power, and frequency offset … Read more
CONTROL BUTTONS ① Power Button Hold to start/shut down the speaker. Under PC/Flash Disk mode, Nature Effect mode, or AUX mode, click to roll back to Bluetooth mode. ② Plus Button Click to crease volume(tone at maximum), Hold to switch next song ③ Play/Pause Click to Play/Pause, Hold to disconnect present Bluetooth. ④ Minus Button … Read more
Introduction to beep: unconnected, unpaired, successfully paired, plug in the charging cable, when the battery is low, it will beep when found (the non-beep version does not have this function) Bluetooth factory name: Airpods pro Purpose: Listening to songs, videos, phone calls, WeChat voice Other functions: smart warehouse, three-true battery, pop-up connection, Bluetooth connection, Apple … Read more
====================================== Steps to use： 1. Connect the hardware (USBDBG or TRB), click “Port init” to initialize the port 2. Check the key values that need to be retained. Generally check the Bluetooth address and frequency offset parameters. licensekey checks according to whether it is used in its own products, and don’t check if it is … Read more
Instructions for use: 1. Select the corresponding chip series according to the actual chip 2. Select burn file 3. Set the starting address, the address will be automatically remembered after closing the tool, and the next time it is opened, it will be the address of the last burning. 4. Select the port, you need … Read more
Instructions for use: 1. Select the corresponding chip series according to the actual chip 2. Select burn file 3. Set the starting address, the address will be automatically remembered after closing the tool, and the next time it is opened, it will be the address of the last burning. 4. Select the port, you need … Read more
Instructions for use: 1. ReadAll Read device configuration 2. WriteALL writes the configuration to the device 3. WriteName Writes the Bluetooth name to the device 4. WriteAddress Writes the Bluetooth address to the device (the address will be automatically incremented by 1) 5. WriteLoadCap and WriteTrim write crystal oscillator parameters to the device 6. OpenFW … Read more
Step 1: Find an Android phone to install the SDK development tool, AB1562-v1.2.2.2020071618-release.apk (in the attachment) Step 2: Copy the NV folder from the zip file attached to this article into your Android phone storage drive. popup_on.nvr file is to open the popup window popup_off.nvr file is to close the popup window Step 3: After … Read more
What should I do if the bluetooth cannot be searched occasionally? It is recommended to restart Bluetooth and try searching again. What should I do if the Bluetooth cannot be found? Check whether the Bluetooth of the mobile phone is turned on,whether the GPS positioning is turned on(the system requires that the search for Bluetooth … Read more